PoolCalc.

Pool shock calculator

The shock level your CYA actually calls for, the rise from your current reading, and the product that gets you there — instead of a fixed "one bag per 10,000 gallons".

Default result

2.25 gal (288 fl oz) of 10% liquid

Raise FC from 1.0 to 16.0 ppm · CYA 40 ppm

Shock level 16.0 ppm CYA 40 ppm × the published shock chart
Free chlorine now 1.0 ppm From your test
Chlorine to add 15.0 ppm Difference, not a fixed dose
Dose 2.25 gal (288 fl oz) 10% liquid chlorine, 288 fl oz
How long to hold Retest at 12 h until the water is clear and the overnight FC loss is 1 ppm or less
  • Shock level is not a fixed number: it rises with CYA. At 40 ppm CYA the published level is 16 ppm; at 80 it is 31 ppm.
  • Dosing to a fixed 10 ppm in a high-CYA pool is why some shocks appear to do nothing.

Before you dose

  • Do not swim until FC is back below the normal target range and the water is clear. High FC with high CYA is less harsh than the number sounds, but it is still not swimming water.
  • Brush the walls and floor, run the pump continuously, and clean the filter when the pressure rises 8 to 10 psi over clean.
  • Vinyl liners, natural stone and coloured plaster can be damaged by undissolved cal hypo. Pre-dissolve dry product in a bucket of pool water and pour it in front of a return.
  • If CYA is above 90 ppm, drain and refill before shocking. The dose needed at that CYA is large and the result is unreliable.

Other ways to do it

  • 12.0 ppm — A maintenance shock for a cloudy pool with no visible algae.
  • 16.0 ppm — The full SLAM level for green water or a failed overnight test.

The default pool: CYA 40, FC 1 ppm

At 40 ppm CYA the published shock level is 16 ppm. The pool is at 1 ppm, so the dose has to add 15 ppm. In 15,000 gallons that is 2.25 gallons of 10% liquid chlorine, or 2.6 lb of 73% cal hypo, or 3.4 lb of 56% dichlor. The same pool at CYA 80 would need 31 ppm and roughly twice the chlorine — which is the point of this page.

Most shock instructions are written as a fixed amount per 10,000 gallons. That works only if your CYA happens to be in the range the label assumed. Once CYA is above about 50 ppm, a fixed dose is often below shock level, and the pool stays cloudy while you keep adding product.

Shock level by CYA

CYA (ppm)Shock / SLAM level (ppm FC)Rise from 1 ppm
20109
301211
401615
502019
602423
702827
803130
903534
1003938

The table is community practice from Trouble Free Pool, not a health code. It exists because higher CYA binds more of the chlorine, so a higher measured FC is needed to keep the same active concentration. If your local code sets a maximum FC for a public pool, that rule wins for a public pool; this page is about a residential pool you maintain yourself.

The SLAM process, in order

  1. Get pH to 7.2–7.5 first. Chlorine is much less effective at high pH, and the pH test does not read accurately above 10 ppm FC.
  2. Remove what you can. Net out leaves and debris. Chlorine oxidises them, but it cannot outrun a pile of organic matter.
  3. Dose to the shock level for your CYA — the number above, not a fixed bag count.
  4. Brush the walls and floor and run the pump continuously. Algae hides in corners and under ladders.
  5. Retest and top up. Free chlorine falls fast in the first hours. Test every few hours and bring it back to shock level.
  6. Hold until three things are true: the water is clear, combined chlorine is 0.5 ppm or less, and the pool loses no more than 1 ppm of FC overnight.
  7. Clean the filter when pressure rises 8 to 10 psi over clean. A SLAM produces a lot of dead algae for the filter to catch.

Do not swim during a SLAM. Not because the number is automatically dangerous, but because you cannot see the bottom, the filter is working hard, and the chlorine demand means the level is unstable.

Choosing the product

ProductFor this 15 ppm riseWhat else it adds
10% liquid chlorine2.25 gal (288 fl oz)Salt, a little pH rise
12.5% liquid chlorine1.8 gal (230 fl oz)Salt, a little pH rise
73% cal hypo2.6 lbCalcium hardness, pH rise
56% dichlor3.4 lbCYA — the opposite of what a high-CYA pool needs

Liquid chlorine is the default for a reason: it adds almost nothing except chlorine and salt, so it does not quietly raise CYA or calcium while you are trying to fix an algae problem. Cal hypo is fine if your calcium is low and you pre-dissolve it carefully. Dichlor is the worst choice for shocking a pool that already has enough stabilizer, which is most pools that need shocking.

What this calculator cannot tell you

If the shock keeps failing, check the CYA level and the filter sizing before buying more chlorine. The maintenance dose page is the right tool once the water is clear again.

Frequently asked

How much shock for a 15,000 gallon pool?

At CYA 40 ppm the shock level is 16 ppm. From 1 ppm that is a 15 ppm rise, about 2.25 gallons of 10% liquid chlorine, or 2.6 lb of 73% cal hypo. At CYA 80 the level is 31 ppm and the dose roughly doubles.

Is shock a product or a dose?

A dose. "Shock" means raising free chlorine to a level that oxidises contaminants faster than a maintenance dose. The product you use is just a chlorine source; the number that matters is the target ppm for your CYA.

Can I swim after shocking?

Not until free chlorine has fallen back into the normal range for your CYA and the water is clear. For a SLAM that usually means the next day at the earliest, and only after an overnight test shows the pool is holding chlorine.

Why did my shock do nothing?

Usually because the dose was set by the pool size instead of the CYA. At 80 ppm CYA, 10 ppm of chlorine is below shock level and will be consumed without clearing the pool. High CYA is the most common reason a shock fails.

How often should I shock?

A well-run pool does not need a weekly shock. Shock when combined chlorine is above 0.5 ppm, when the water is cloudy or green, or after a contamination event. Routine shocking hides a filtration or CYA problem instead of fixing it.

Where these numbers come from

Figures that come from our own arithmetic rather than a published guide are marked house rule on the method page. No price is shown anywhere on this site.

Related: free chlorine · CYA · filter size · pool volume