PoolCalc.

Pool water math, with the formula showing

How many gallons your pool holds, how much chlorine that needs, how much salt it takes to get there. Eight calculators built on published charts and plain mass balance, each one showing the number it used and the place where the estimate stops being exact.

Start with the volume Or look up a common pool size

Calculators

Pool volume

Gallons and cubic feet for rectangular, round, oval and kidney pools.

Free chlorine

The dose to reach the FC target your CYA calls for, in the units on the bottle.

Salt

Pounds and 40 lb bags to move a salt pool to its target ppm.

Shock

SLAM level by CYA, and the product that gets a green pool there.

Pump run time

Hours per day from volume, flow and turnovers, with a two-run split.

Heater size

BTU, efficiency and the hours to raise the water a given number of degrees.

Filter size

Cartridge, sand or DE area for the flow your pool actually runs at.

CYA / stabilizer

Stabilizer to raise cyanuric acid, or water to replace to lower it.

Guides

Pool gallon chart

Common rectangular, round and oval sizes, with the depth each figure assumes.

How long to run a pool pump

Turnovers, skimming, chlorine and the energy case for running slower.

One pool, start to finish

A 16 × 32 ft pool, 3.5 to 6 ft deep

The default on every calculator is this pool. Here is what the numbers look like together.

18,193 gal

Volume at a 4.75 ft average depth, 512 sq ft of surface.

Volume calculator

77 fl oz

10% liquid chlorine to lift FC from 2 to 6 ppm at CYA 40.

Chlorine calculator

75 lb

Salt to go from 2,600 to 3,200 ppm — two 40 lb bags.

Salt calculator

Change the pool size on any page and the others still apply, because every dose is driven by the same volume. The full chain is on the method page.

Why pool maths goes wrong

Most pool advice is a fixed number: one bag per 10,000 gallons, eight hours a day, shock weekly. Those numbers are not random, but they assume a pool that looks like the one the writer had in mind — a certain volume, a certain stabilizer level, a certain bather load. Change one of those and the fixed number is wrong in a way you cannot see.

The worst offender is cyanuric acid. A pool at 30 ppm CYA and a pool at 90 ppm can both read 3 ppm free chlorine and be completely different pools: one is sanitised, the other is on its way to algae. That is why the chlorine and shock pages start with CYA rather than with the pool size, and why the CYA page is worth reading even if your stabilizer is fine.

The second is volume. A pool store's "20,000 gallons" is usually a rounded guess. On a 16 × 32 pool the difference between a 4 ft and a 4.75 ft average is about 2,900 gallons — enough to put a salt dose two bags out and a CYA dose half a pound out, and those are the two chemicals that do not leave the pool on their own.

How to use the site

  1. Get the volume once. Measure the length, width and both depths, and use the volume calculator. Write the number down; it is the input to everything else.
  2. Test the water. Free chlorine, combined chlorine, pH, alkalinity, calcium and CYA. A FAS-DPD kit is worth the money if you are going to dose from numbers.
  3. Fix the order: pH first, then chlorine, then salt and stabilizer. Chlorine works badly at high pH, and CYA and salt change the targets for everything after them.
  4. Dose, then verify. Every calculator here gives an estimate. Retest after 30 to 60 minutes for chlorine, after 24 hours for salt and CYA.

What is different here

Where the numbers come from

The FC/CYA targets and shock levels are the published Trouble Free Pool chart, which is community practice rather than a regulation and is labelled as such. Volume arithmetic uses the US gallon definition and the average-depth method PoolMath publishes. Physical constants come from NIST SP 811, and the energy and efficiency figures from ENERGY STAR. All 7 sources are listed with links and the date we checked them on the method page.

Frequently asked

How many gallons is my pool?

Length × width × average depth × 7.48 for a rectangle; π × radius² × average depth × 7.48 for a round pool. A 16 × 32 pool averaging 4.75 ft holds about 18,200 gallons.

How much chlorine should I add?

Enough to reach the target for your CYA, not a fixed amount. At CYA 40 ppm the target is 5 to 7 ppm FC; a 15,000 gallon pool at 2 ppm needs about 77 fl oz of 10% liquid chlorine to reach 6 ppm.

Why does this site show a result before I press anything?

Every calculator is rendered with a default pool at build time, so the number is in the page HTML. Change a field and the same arithmetic runs in your browser.

Are these numbers safe to follow?

They are planning figures from published charts and plain arithmetic, not a test kit. Confirm the dose against your own reading and the product label, and follow local rules for draining, gas equipment and public pools.